Troubleshooting

The Chevy Malibu’s Service Stabilitrak system is designed to help keep the car stable and in control during adverse driving conditions. The system monitors the car’s speed and steering inputs, and can detect any unusual movements or vibrations that may indicate a lack of stability. If the Stabilitrak system detects an issue, it will alert…

Nissan Altima jerking when driving is a common issue that many Nissan Altima owners experience. This issue can be caused by a variety of factors, including worn or damaged spark plugs, faulty wiring, or a faulty fuel injector. Other causes include dirty air filters, low octane fuel, and a clogged exhaust system. In order to…

The 2011 Honda Accord utilizes a 22mm axle nut size for the rear wheel axles. This size is used on all four-cylinder and V6 models, as well as the Hybrid model. The axle nut must be tightened to a torque specification of 107 foot-pounds with a torque wrench. Failure to properly tighten the axle nut…

If your car battery has jumped and then died again, the cause could be a variety of things. It is important to inspect and diagnose the problem in order to identify the underlying cause. Potential causes of a jumped battery that dies again include poor connections, faulty battery components, parasitic draws, alternator problems, and wiring…

A high rpm low speed automatic is a type of transmission system found in many modern vehicles. It is designed to provide smooth and efficient shifting between gears while allowing the driver to keep the engine running at a lower RPM, resulting in improved fuel economy. The transmission uses multiple gear ratios to help maintain…

The 2006 Honda Accord has a coolant capacity of 4.7 liters (4.9 US quarts). This is the total capacity for the engine cooling system, including the reservoir. The engine coolant should be changed every 30,000 miles or two years, whichever comes first. To check the coolant level, make sure the engine is cold and then…

U-joints, also known as universal joints, are a critical component of the drivetrain in many vehicles. They are responsible for transferring power from the transmission to the driveshaft, and they are subject to wear and tear over time. The lifespan of u-joints depends on a variety of factors including the type of vehicle, how it…

Driving on warped rotors is a condition where the metal of the vehicle’s brake rotors becomes unevenly worn or bent. This leads to vibrations in the steering wheel and brake pedal when braking. It can also cause an increase in stopping distance, as well as an uncomfortable ride. Warped rotors can be caused by several…

Drive shaft seal replacement is a procedure used to replace worn or damaged seals located in a vehicle’s drive shaft. The drive shaft is a component of a car, truck, or other motor vehicle that transfers power from the engine to the wheels. It consists of two parts, an inner and an outer section; the…

Check engine light flashing then goes away is a common problem that many vehicle owners face. It is usually an indication of a malfunction in the engine or the emission control system. The check engine light is a warning that something is wrong with the engine and needs to be addressed immediately. If the light…