Troubleshooting

Front wheel leaning inward at the top is a phenomenon that is commonly seen in bicycles. It occurs when the angle of the fork or axle that holds the front wheel is too steep and causes the wheel to lean inwards, rather than remain straight. This can cause difficulty in steering and handling, as well…

A caliper piston boot is a rubber boot that is used to seal and protect the brake caliper piston from dirt and debris. It is typically found on vehicles with disc brakes. When the caliper piston boot becomes torn, it can cause dirt and debris to enter the braking system, resulting in poor performance of…

Speed Sensitive Volume Control (SSVC) is a feature that automatically adjusts your device’s volume according to the speed of the vehicle. This can be helpful when driving, but can be a nuisance when you are stationary or in a quiet environment. To turn off SSVC on most devices, you will need to access the settings…

Code P2195 is a diagnostic trouble code (DTC) indicating an issue with the oxygen sensor signal that is being sent to the engine control unit (ECU). This code is usually caused by a bad or failing oxygen sensor, a wiring issue, or a vacuum leak. The oxygen sensor measures the amount of oxygen in the…

2004 Honda Accord Oil Leak Passenger Side is a common problem for this model of car. The cause of the oil leak is usually due to a faulty gasket, seal, or other component located on the passenger side of the engine. In some cases, the oil may be leaking from the drain plug, filter, or…

The average cost of an oil change for a Ford F150 can vary according to the type of oil used, the type of service performed, and the location of the service. Generally speaking, the average cost of an oil change for a Ford F150 ranges between $45 and $115 depending on these factors. The most…

Colorado engine swap laws are designed to ensure that vehicles operating in the state remain compliant with safety regulations. These laws cover everything from the types of engines that can be legally installed in a vehicle, to the modifications that must be made in order to use an engine from a different make or model….

Replacing the brake pads on a VW Golf is an important procedure to ensure your vehicle’s braking system remains in top operating condition. The cost of replacing the brake pads on a VW Golf depends on various factors, such as the type of brake pad, make and model of the vehicle, labor costs, and more….

The check engine light is an indicator that something is wrong with your vehicle. When the check engine light comes on, it usually indicates that there is a problem with the engine or its associated systems. One of the most common causes for the check engine light to come on is low oil levels. Low…

Intake Manifold Runner Control (IMRC) is a system used to regulate the air flow in an engine. It helps to optimize the air/fuel mixture and provide better fuel economy. When the IMRC gets stuck closed, it can cause performance issues such as stalling and reduced power. Fortunately, fixing a stuck closed IMRC is relatively easy….